Electronic Journal Technical Acoustics ISSN 1819-2408

N. V. Volkova

Built-up rubber-metal vibroisolators

language: Russian

received 19.05.2005, published 15.09.2005

Download article (PDF, 320 kb, ZIP), use browser command "Save Target As..."
To read this document you need Adobe Acrobat © Reader software, which is simple to use and available at no cost. Use version 4.0 or higher. You can download software from Adobe site (http://www.adobe.com/).

ABSTRACT

Two types of built-up vibroisolators in which elastic elements are cut out from rubber plates are presented. Constructions of vibroisolators allowing to decrease labor expenditures at manufacturing are suggested. Results of experimental verification of the basic vibroisolators characteristics and comparison of the obtained results with computed estimations are presented.

9 pages, 6 figures

Сitation: N. V. Volkova. Built-up rubber-metal vibroisolators. Electronic Journal “Technical Acoustics”, http://www.ejta.org, 2005, 31.

REFERENCES

no references

Natalia Volkova graduated from Leningrad Shipbuilding Institute (Marine Technical University). Principal engineer at Krylov Shipbuilding Research Institute (St. Petersburg, Russia). More than 14 years experience in noise and vibration control, author of several publications on vibroisolation. e-mail: nat_wolf(at)mail.ru